With a LED Indicator and a beeper to indicate the charging status
Reverse and short circuit protection
Operation Instruction:
This charger can be powered either by alternating curren(AC)230V or by direct
current(DC)12V. AC and DC sources can not be together used at the same time.
When power supply is on, the beeper will sound and the indicator will flash once.
Connect up the battery pack, the charger beep again; the LED will repeatedly blink
until you begin the charging progress.
Select the the charge rate based on the battery capacity rating. Take a look at
"Charge Time".
Push the Start button to begin the charger process
Once the battery has peaked, the LED will flash, and the beeper will sound for about
30 seconds. If the battery pack is still left connected, the indicator will continue to
flash, and the beeper will sound approximately every 90 seconds.
When charging is finished, remove the battery immediately after power supply is
off.
Recharging:
Once the battery pack has
reached its saturation and is on trickle charge (the indicator will flash, and the beeper
will sound for 30 seconds), you
can recharge the battery by simply pushing the Start button without
disconnecting the battery from charger. Don't recharge the battery more than
once during a charging procedure.
Charge Time: The following are the approximate
minutes needed for charging after batteries are fully discharged.Please note these are
estimated minutes only.
1 Amp
600mAh TX/RX Pack: 36 minutes
700mAh TX/RX Pack: 42 minutes
1000mAh TX/RX Pack: 60 minutes
2 Amp
1000mAh TX/RX
Pack: 30 minutes
4 Amp
1500mAh 6-cell Sub-C Car Pack: 23 minutes
2000mAh 6-cell Sub-C Car Pack: 30 minutes
3000mAh 6-cell Sub-C Car Pack: 45 minutes
3300mAh 6-cell Sub-C Car Pack: 49 minutes
3800mAh 6-cell Sub-C Car Pack: 57 minutes
Caution:
Always take close attention to the charging while charging.
Keep the charger in a cool and ventilative condition during every charging.
The charger can not be connected together to AC230V and DC12V power source at the same
time.
While an automobile is running, the charger is not allowed for connection with its 12V
current of the vehicle.
Note that the positive pole and the negative pole should be properly connected.
Write a Review:
Please sign in your member account to write a review.